Spray Machine For Drying
The spray dryer puts the dryer in place, but connects the pipe to the heating unit.
Put the heater in place; according to the equipment layout of the factory, hang the cyclone separator and the bag filter at a predetermined position, first connect the pipe between the drying host and the cyclone separator, and then connect the cyclone separator and the bag filter stand up. Blast furnace, blower and air filter.
At the same time, a pipe is connected between the bag filter and the induced draft fan. Correct the verticality of the drying host to the ground. The verticality between the top of the drying host and the ground should not be greater than 10mm; the paper feeder is in place and connected to the drying host; when connecting each pipe, an asbestos rope or sealing strip should be embedded (silicone rubber is required Washers should be used to meet GMP requirements); fasteners should be fixed at each connection until the fasteners are tightened and are not loose; the cabinet circuit should be connected to the cabinet, the cabinet should be firmly grounded, and marked with clear signs (wires should be Through the housing or cable box)
Centrifugal spraying nozzle transmission mode
compressed air transmission
Rotation speed (r.p.m)
Spray disc diameter
electricity + steam, fuel, oil, fuelgas
solved by user
Max. electric heating power (kw)
Powder recollection (%)