Before drying, charging the material into the feed hopper, spread evenly over the belts. The materials on the belt move forward at a constant speed by drive motor. The hot wind will enter the drying chamber, going up and through the material evenly. When the hot wind contact the material, the temperature of material will go up rapidly. The materials absorb the hot wind and release the moisture. Through the fan, the moisture will be exhausted out. Thereby finishing the heat exchange process, meanwhile the materials dried up at the same time.
Each mesh-belt has its own driving motor, and can be frequency control by themselves, which can control the feeding speed and drying time effectively, which can meet the requirement of the final moisture. Both of the belt has striker plate, which can prevent the material on the track and chains. There are 12 pieces of stay bars supporting the belt. The stay bar has been fixed on the chain of both sides tracks.(the ball of chain is moving flexibly, which is good at keep moving.)Die-pin and belt is fixed by the bolt, prevent moving together, which can keep the belt safe and lengthen its working life. On both sides of feeding and discharging port, there is the main shaft. The main chain wheel is fixed on the both ends of main shaft.
The 12 channel steel on the bottom of the equipment and 5 square tube around the body skeleton are welded together as a entirety. The thickness of thermal insulation is 50 mm, which is made of high quality aluminum silicate cotton. It can be used to reduce heat loss. The inner of equipment is 1.0 mm stainless steel plate, rivets. The outside is 1.2mm A3.The induced draft fan is made of A3. On one side of the equipment, there are the One observation door and the clean door, which can help you to know the details about the process and working cooling. The thermocouple is equipped inside. which can show the temperature inside by XMT instruction.
1.5m， 10mesh SUS304
10m X3 Floor：3
5Unit(2 m is as a unit, with one circulation fan.)
10- 50 mm
|Drying temperature||80-- 120℃|
|Drying time||1.5- 2.5h，controlled|
|Drive motor||1.1KW 2pcs|
|Circulation fan||4-72 2.2KW 5sets|
|Exhaust fan||4-72， 2.2kw， 2sets|
|Exhaust pipe||1.2mm SUS304|
|Total installation power||18kw|
Q1:Are You A Factory or A Trading Company?
A: We Provided Perfect OEM and After-sale Service.
Q2:Where is Your Factory? How Can I Visit Your Factory?
A:Our Factory is Located on HangZhou Zhejiang Province. We Are Warmly Welcom You Visit Our Factory if You Have a Travel Plan.