Ointment Manufacturing And Herbal Product Processing Equipment is to dry the material under the action of hot air, feed the material from the high end, and discharge the lower end of the material. In the process, it is dried by hot air to achieve the purpose of drying the material. The raw material is fed from the upper end (high end) of the cylinder, passes through the inside of the cylinder, is dried in contact with hot air passing through the cylinder, and the dried product is collected from the bottom of the other end (low end). The main part is a cylinder that is slightly inclined and can be rotated.
In the work of Ointment Manufacturing And Herbal Product Processing Equipment, the material is slowly rotated by the cylinder, and the material moves to the bottom due to gravity. The copy board inside the cylinder raises and throws the material to make the material fully contact with the hot air to increase the drying rate. The cylinder is the base of the rotary dryer, so it is necessary to ensure that the cylinder has sufficient rigidity and strength. The material is generally selected by Q235 steel to check the cylinder.
The cylinder is thermally expanded, so it is necessary to connect the cylinder and the gear with a spring plate to counteract the force of the cylinder when it is heated. This should also be the case between the roller and the barrel. Ointment Manufacturing And Herbal Product Processing Equipment is indirectly heated and dried to prevent the loss of hot air. In order to prevent damage to the cylinder caused by hot air and heated materials, it is necessary to line. Increase the contact area and increase the drying rate. The Ointment Manufacturing And Herbal Product Processing Equipment has a copy board inside.