The first step, wear a film
When you get the film, you need to confirm the winding direction of the film, find out the counterclockwise direction, and put it on the film rod to fix it. (Please turn off the power when wearing the film)
Pay attention to whether the front and back fixing splints of the film are tightly combined with the film. If they cannot be tightly connected, use a utility knife to cut the inside of the film tube at an oblique angle before placing it.
After wearing the film, use adhesive tape to stick the film firmly to the receiving paper tube.
Portable chain dynamic sealing machine
The second step, sealing operation steps (panel operation instructions)
Turn on the power, turn on the power switch, the indicator light is on, set the thermostat to a predetermined temperature, then the green heating indicator light is on. When the upper hot plate reaches the predetermined temperature, the red constant temperature indicator light is on (when the sealing machine is working, the electric heating device continuously alternates in the heating and heat preservation state, so the green and red indicator lights also alternately display, which is normal).
Put the plastic cup into the lower mold slide, and push the lower mold slide to a certain position by hand (if it is an automatic sealing machine or an automatic sealing machine, the lower mold slide will automatically enter after putting the plastic cup), press down The handle of the sealing machine reaches the maximum stroke, keep the pressure for 1 ~ 2 seconds, then slowly raise the handle and push it to the original position.
Pull out the lower mold slide, take out the plastic cup, put in the last sealed plastic cup, and perform another cycle.